|
C section shed has between 4 and 5 times more parts than an “ULTRAFRAME”® Pre Fabricated shed.
Therefore it will take you much more time checking off your Bill of Materials.
You will also need to identify what each part is.
With your haunch brackets you need to ensure you have the correct number of left and right brackets.
Depending on the size and type of shed this could take between 30 minutes and several hours.
These are the important parts you will need to identify:
- Columns
- Rafters
- Mulliions
- Purlins
- Side Girts
- End Girts
- Haunch Brackets
- Apex Brackets
- Eave Purlin Brackets
- End Girt Brackets
- Base Cleats
- Mullion Base Cleats
- Mullion Top Angles
- Knee Brace
- Apex Brace
- Flashings
- Fasteners
Your shed will also have extra parts for roller doors, sliding doors, P/A Doors, mezzanine floors etc.
These parts will be the same whether the shed is C Section or “ULTRAFRAME”®.
|
As all FRAME brackets are welded to the “ULTRAFRAME”® Pre Fabricated shed your check list is very small and easy to identify.
Its very simple: if you have all of your columns and rafters, then you have all of your brackets !!!
These are the important parts you will need to identify:
- Columns
- Rafters
- Mullions
- Purlins
- End Girts
- Side Girts
- Flashings
- Fasteners (“ULTRAFRAME”® Pre Fabricated shed requires only 25% the number of fastening bolts and tek screws. A C Section shed has ALL brackets welded to the frame).
Your shed will also have extra parts for roller doors, sliding doors, P/A Doors, mezzanine floors etc.
These parts will be the same whether the shed is C Section or “ULTRAFRAME”®.
|
Why UltraFrame? 
